A four-hour disruption to air travel in the US was caused by the replacement of an outdated copper cable with fibre optics, which triggered a cascade of communication failures at air traffic control centres. This was reported by The New York Times.
According to US Transportation Secretary Sean Duffy, on 13 November a contractor was carrying out work to replace analogue copper wires with more modern fibre-optic cables. The work was being done at a small, remote facility, so the Federal Aviation Administration (FAA) did not expect any noticeable impact on air traffic.
However, after the switch to fibre optics, the system received a volume of data it was unable to cope with. This led to a cascade of communication failures, after which the authorities decided to halt departures across the entire country.
According to The Wall Street Journal, the requests that overloaded the system came from two nodes, in Arkansas and Texas. Shortly before the failure, a new router had been installed in Arkansas, which began transmitting a huge volume of data.
“We are now trying to establish whether there was incompetence, that is, an error by a user or installer on the part of L3Harris, or whether they installed a faulty router. We have not yet identified the source of the fault,” Duffy told journalists.
Such work is usually carried out at night. Aviation officials considered that upgrading the equipment during the daytime should not affect air travel.
Following the incident, Duffy said the agency would review the schedule for carrying out such work.
As previously reported, on 14 November the FAA temporarily suspended departures from all airports in the US due to a large-scale failure. According to FlightAware, more than 15 thousand flights were delayed as a result, and over 700 more were cancelled the following day.